Applications: 02-04 RSX Type S, RSX Base or EP3 with Type S or K24 Swap without extra power wire.
- All plugs included (Fan Switch, IACV, Coolant Temp Sensor, Both Knock Sensor Plugs)
- Covering is gas and diesel resistant and rated for -55° C to 150° C (-67Â° F to 320° F)
- SAE Certified Automotive Grade Wiring
- All plugs are labeled
- Tucked design
- Harness runs over valve cover (Can be covered with coil pack cover)
- Injector wiring runs from under manifold between middle runners.
- Ground wire relocated to stud under coil pack cover (instead of front of the valve cover)
- Includes single wire temp sensor wire (For k-swap cars stock cluster)
- 3 Aux wires run from ECU to under intake manifold. Two ECU pins pre-installed.
- Wiring long enough for both VSS low frequency or high frequency (High Frequency transmissions will require repining plug and slight modification to VSS)
- Extra knock sensor plug included.
- Each harness is inspected and tested before shipping.
- RDX injectors plugs come standard (RSX Type S injectors use the same pin. Can be easily switched)
- Standard (No Power Wire) harness slightly smaller and more flexible.
- Street-Grade w/Standard Heat=Shrink Loom
K Series engine swap requried
Base Model RSX and EP3 require 02-04 Type S swap or K24 with K20A2 Transmission
- 2002 -2004 Acura RSX Manual
- 2002-2004 Acura RSX Type-S
- 2002-2005 Honda Civic Si Hatchback
There are no reviews yet.